Fiat 2 Berth - Hot Water Unit on 240V and Gas (User Guide)

Your 2 Berth Motorhome is equipped with a dual-mode hot water system that can operate on 240V power (while plugged in at a campsite) or on LPG gas. Follow the steps below to ensure you always have hot water available during your trip.

Mode 1: 240V Power (When Plugged in at a Campsite)

1. Plug your vehicle into a powered campsite connection.

2. Wait at least 20 minutes for the water to heat up automatically.

3. No further action is required — your hot water will be ready to use.

Mode 2: LPG Gas (When Off-Grid)

1. Locate the gas compartment on the driver’s side of the vehicle.

2. Open the gas bottle all the way (turn anti-clockwise) to ensure a steady gas flow.

3. Turn on the following:

4. Hot water switch

5. Water pump

6. White switch

7. Push the hot water thermostat switch up to 60°C.

8. The water will heat up within 30 minutes.

If the Red Light Stays On (Gas Ignition Failure)

If the system fails to ignite on gas mode:

1. Double-check the gas fitting and ensure the bottle is fully open.

2. Push the thermostat switch back to the neutral position and leave it for a few minutes to reset.

3. Make sure your motorhome is completely level — the system will not operate correctly if it’s on an angle.

Tip:

You’ll need to heat up the water manually on gas 30 minutes before use. Each hot water cycle lasts for approximately 3 minutes.

Need More Help?

If you experience any issues or need more guidance:

1. Call us at 1300 016 532

2. Watch the tutorial video for a step-by-step demonstration

3. Check the full PDF guide for visual references and troubleshooting steps